Replacement
1. Locate the electric motor connector on the main harness by wire and
disconnect the connector.
2. Check the resistance between terminals 2 and 3 of the connector. The resistance should be 0.3–100 Ohms. Otherwise, replace the electric motor.
3. Check the insulation resistance (between terminals 2 and 3 and ground), which should be no less than 0.5 Ohm. Otherwise, replace the electric motor.
4. Disconnect the breather hose and the electric drive connector.
(The publication is taken from the website: Toyotaman.ru)
5. Loosen the bolts and remove the electric motor.
6. Installation is carried out in reverse order.