Removal and installation
1. Disconnecting the steering knuckle from the knuckle shaft (connecting the bipod to the bipod shaft).
a) Loosen the steering knuckle nut.
b) Using a puller, disconnect the bipod from the bipod shaft.
c) When assembling, align the alignment marks on the bipod and bipod shaft, and install the spring washer and nut.
2. Using a puller, disconnect the steering arm from the transmission rod.
3. Using a puller, disconnect the transmission rod from the steering knuckle arm.
4. Using a puller, disconnect the damper from the transverse rod.
5. Using a puller, disconnect the damper from the cheek.
6. Using a puller, disconnect the transverse rod from the steering knuckle arm.
7. Adjusting the transverse or transmission rod (if necessary).
a) Loosen the tie rod end clamp and remove the end.
b) Screw the rod ends into the rod tube to the same length.
Length of the thrust - 1207 mm
c) The lengths of the free threaded sections of both tips must be equal.
d) fastening the clamps of the rod ends.
Tightening torque - 44 Nm