Note: If the bearing was disassembled, install the inner rings in the same places as before disassembly.
a) Remove the inner rings from the new bearing.
b) Using a suitable mandrel and press, install the new bearing.
c) Install the inner rings.
2. Using the special tool, install a new retaining ring.
Note: Do not damage the bearing.
3. Using the special tool and a hammer, install the new outer oil seal.
Note: Apply grease to the seal lip.
4. Install the brake shield and tighten the four nuts.
- Tightening torque - 73 Nm
5. Using a special tool and a press, install the hub.
6. Using the special tool and a hammer, install the new inner oil seal.
(The original source is located on the website: toyotaman.ru)
Note: Apply grease to the seal lip.