Contents: Removal ↓ Installation ↓
Removal
1. Jack up the car and remove the rear wheel.
- Tightening torque - 105 Nm
2. (Drum brakes)
Remove the brake drum.
3. (Disc brakes)
Remove the caliper and brake disc.
- Tightening torque - 48 Nm
4. Remove the speed sensor (ABS).
- Tightening torque - 8 Nm
5. Remove the rear wheel hub.
6. (Disc brakes)
Remove the dust cover.
7. (Drum brakes)
Disconnect the pipe and remove the brake mechanism assembly.
- Tightening torque - 16 Nm
8. Remove the fist.
a) Disconnect the trailing arm from the knuckle.
- Tightening torque - 115 Nm
b) Unscrew the two nuts securing the knuckle to the strut.
- Tightening torque - 260 Nm
c) Disconnect the lower suspension arms No.1 and No.2 from the knuckle.
- Tightening torque - 185 Nm
d) Remove the two bolts securing the knuckle to the rear suspension strut and the knuckle.
Installation
1. Installation is carried out in the reverse order of removal.
2. Tightening the bolts securing the lower and longitudinal arms to the knuckle is done after the suspension has been stabilized. In order to finally tighten the nuts securing the arms, it is necessary to jack up the knuckle.
