Removing
Remove the rear wheel.
Remove the rear suspension brace assembly.
Disconnect the disc brake caliper.
Remove the rear disc.
Disconnect the skid control sensor wire.
Remove the rear wheel hub.
Pic. 3.155. Bolt of fastening of the rear suspension arm No. 2 to the knuckle of the rear suspension hub
Remove the mounting bolt and nut and remove the rear suspension arm No. 2 from the knuckle of the rear suspension hub (pic. 3.155).
Pic. 3.156. Bolt of fastening of the rear suspension arm No. 1 to the knuckle of the rear suspension hub
Remove the mounting bolt and nut and remove the rear suspension arm No. 1 from the knuckle of the rear suspension hub (pic. 3.156).
Note. Turning away a bolt, fix a lock nut of levers of a back suspension bracket.
Pic. 3.157. Bolts of fastening of a fist of a nave of a back suspension bracket
Remove the 2 mounting bolts and nuts and remove the rear suspension hub knuckle from the rear suspension shock absorber strut (pic. 3.157).
Installation
Install the rear suspension hub knuckle with 2 bolts and nuts.
Tightening torque: 255 Nm.
Attach the No. 1 rear suspension arm to the rear suspension hub knuckle with a bolt and nut, temporarily tightening the bolt.
Note. Insert the bolt from the front of the vehicle and rotate the bolt while installing the nut.
Note. Attach the No. 2 rear suspension arm to the rear suspension hub knuckle with a bolt and nut, temporarily tightening the bolt.
Note. Install the rear wheel hub.
Note. Install the skid control sensor wire.
Note. Install the rear disc.
Note. Install the disc brake caliper.
Note. Temporarily tighten the rear suspension brace assembly bolts.
Note. Stabilize your suspension.
Pic. 3.158. Bolts of fastening of the lever of a back suspension bracket No. 1
Fully tighten the No. 1 rear suspension arm mounting bolts (pic. 3.158).
Pic. 3.159. Bolts of fastening of the lever of a back suspension bracket No. 2
Fully tighten the #2 rear suspension arm mounting bolts (pic. 3.159).
Pic. 3.160. Bolts of fastening of an extension of a back suspension bracket assy
Fully tighten the bolts of the rear suspension brace assembly (pic. 3.160).
Install the rear wheel.
Tightening torque: 103 Nm.
Inspect and adjust rear wheel alignment.
Check ABS speed sensor signal.