Contents: Removal the top console panel ↓ Removal the storage compartment on…↓ Removal the parking brake lever ↓ Installing the parking brake lever ↓
Fig. 6.19. Parking brake components
Removal the top console panel
Fig. 6.20. Console top panel fasteners
Using a screwdriver, release the 4 fasteners and remove the top panel of the console (Fig. 6.20).
Note: Wrap the screwdriver blade with electrical tape before starting work.
Remove the rear end panel of the console.
Removal the storage compartment on the console
Remove the cover.
Fig. 6.21. Glove box mounting bolts
Remove 4 bolts and remove the glove box (Fig. 6.21).
Removal the parking brake lever
Loosen the lock nut and adjusting nut.
Fig. 6.22. Parking brake lever mounting bolts
Remove 2 bolts and remove the parking brake lever (Fig. 6.22).
Lift the latch.
Disconnect parking brake cable No.1 from the lever.
Remove the screw and remove the parking brake switch assembly.
Installing the parking brake lever
Install the parking brake switch assembly and secure with the screw.
Connect parking brake cable No.1 to the lever.
Fig. 6.23. Securing the retainer
Press the retainer fully as shown in the figure (Fig. 6.23).
Install the adjusting nut and locknut.
Install and secure the parking brake lever with 2 bolts.
Tightening torque: 14.5 Nm.
Remove the rear wheel.
Adjust the parking brake shoe clearance.
Install the rear wheel.
Tightening torque: 103 Nm.
Check the travel of the parking brake lever.
Adjust the travel of the parking brake lever.