Parking Brake Assembly Components
1 - Pin; 2 - Crank arm of the parking brake drive; 3 - Clamp; 4 - Cotter pin; 5 - Spring; 6 - Cover of the cranked lever; 7 - An arm of the cranked lever; 8 - Parking brake cable; 9 - Internal parking brake cable; 10 - Intermediate lever; 11 - Adjusting washer; 12 - Retaining ring; 13 - Rear disc brake; 14 - Return spring; 15 - Front block; 16 - Spacer plate; 17 - Rear block; 18 - Clamping spring; 19 - Brake disc; 20 - Gasket; 21 - Regulator; 22 - Spring seats; 23 - Shoe holder
The parking brake assembly components are shown in the illustration above.
1. Release the parking brake. Loosen rear wheel nuts. Jack up the car and place it on jack stands. Remove wheels.
2. To take up any slack in the drive cable, loosen the adjusting nut (see Section Parking brake adjustment).
3. Disconnect the cable from the parking brake crank.
4. Disconnect the inner cable from the intermediate lever.
5. Release all cables from the intermediate clamps on the axle frame/case.
6. Installation is carried out in the reverse order.
7. Having finished installation, make adjustment of a drive of a parking brake.
8. Remove the props and lower the vehicle to the ground.