Remove the #1 engine bottom shield.
Removing the starter assembly
Disconnect the starter connector.
Remove the terminal cap.
Pic. 7.22. Wire nut and starter connector
Loosen the nut, disconnect the wire from the starter (pic. 7.22).
Pic. 7.23. Starter mounting bolts
Remove 2 mounting bolts and remove starter (pic. 7.23).
Installing the starter assembly
Install and secure the starter with 2 bolts.
Tightening torque: 37 Nm.
Connect and secure the starter wire with a nut.
Tightening torque: 9.8 Nm.
Note. Make sure the starter wire is at the correct angle.
Put the cap on the terminal.
Connect the starter connector.
Install the #1 engine bottom shield.
Connect the negative terminal to the battery terminal.