Remove the right front wheel.
Remove the top radiator shroud.
Remove the #1 engine bottom shield.
Remove the lower right engine cover.
Remove V-belt #1 (air conditioning compressor drive from the crankshaft pulley).
Remove the alternator drive V-belt.
Removing the support roller assembly
Pic. 7.38. Roller Bolt
Unscrew the bolt and remove the support roller (pic. 7.38).
Remove the front of the exhaust pipe.
Remove the catalytic converter built into the exhaust manifold.
Removing the generator assembly
Pic. 7.39. Bolt of fastening of a plait of wires
Loosen the bolt and remove the wiring harness (pic. 7.39).
Pic. 7.40. Connector and cap #1
Remove the #1 terminal cap and unscrew the nut. Disconnect the generator wire (pic. 7.40).
Disconnect the generator connector.
Pic. 7.41. Alternator mounting bolts
Remove 2 bolts and remove alternator (pic. 7.41).
Installing the generator assembly
Tightening torque: 31 Nm for M8, 47 Nm for M10, 9.8 Nm for alternator wire, 5.0 Nm for wire harness.
Note. Install other components in the reverse order of removal.