Front anti-roll bar installation components
1. Jack up the car and put it on stands. If equipped, remove the crankcase protection.
2. Give nuts (refer to illustration above) and remove the stabilizer bar mounting bolts.
3. Give bolts/nuts of collars of fastening of a bar of the stabilizer of cross-section stability to a car frame.
4. Remove the anti-roll bar from under the car and remove the rubber bushings from it.
5. Assess the condition of the bushings, if necessary, replace them.
6. When installing new bushings, make sure they are slotted forward on the vehicle.
7. Installation is carried out in the reverse order. Make sure all fasteners are tightened to the correct torque (refer to illustration above).