Electric sunroof panel [Toyota Land Cruiser J100]

1. Use the switches next to the personal lighting to open the sunroof flap. The flap will only operate when the ignition switch is in the "ON" position. However, if all the side doors and the tailgate are closed, it will continue to operate for 45 seconds even after the ignition is turned off. It will pause if any of the side doors or the tailgate is opened.

2. The sunshade can be opened and closed by hand.



3. To slide the sunroof panel, press the front side of the switch (refer to the accompanying illustration). The sunroof panel will open completely. To stop the panel halfway, press the same switch or tilt it. The sunshade will open together with the sunroof panel.

4. To close, press the back of the switch. The sunroof panel will close completely. To stop the panel halfway, press the same switch or the tilt switch.



5. To lift, press the "UP" side of the switch. The hatch panel will be fully folded up (refer to the accompanying illustration). To stop the panel halfway, press the same switch or slide switch.



6. To lower, press the opposite side of the switch. The sunroof panel will close completely. To stop the panel halfway, press the same switch or the sliding switch.

7. During sliding, the panel will stop and remain half open if something gets into the gap between the panel and the body. In case of impact on the panel, this function can be activated even without anything getting into the gap.

(The information was taken from a web portal: www.toyotaman.ru)

Note: Never attempt to trap any part of your body in the opening to intentionally activate the anti-pinch feature. The anti-pinch feature may not operate if something gets caught in the opening just before the sunroof is completely closed.