Removing
1. Disconnect a wire from the negative plug of the storage battery.
2. Remove finishing of a forward rack.
3. Remove the instrument panel assembly.
4. Remove the electronic engine control unit.
5. Remove the air conditioning control panel.
6. Disconnect the servo cables as shown.
Installation
1. Connect the inner servo cable to the cable sheath as shown.
Control panel for air conditioning and heater.
1 - air conditioning control panel,
2 - air intake damper servo cable,
3 - servo cable for the air mixing damper,
4 - servo cable for the air flow direction damper.
Air conditioner block.
2. Install the airflow direction servo cable.
A) Set the airflow direction switch to position "VENT".
b) Set the airflow direction damper servo lever to the position "VENT", connect the cable, fix the cable with a clamp.
V) Make sure the servo cable does not come off in both switch positions.
3. Install the air mixing flap servo cable.
A) Set the temperature control to the position "COOL".
b) Set the air mixing flap servo lever to position "COOL", connect the cable, fix the cable with a clamp.
V) Make sure the servo cable does not come off in both switch positions.
4. Install the air intake flap servo cable.
A) Set the air intake control switch to position "CIRC".
b) Set the air intake flap servo lever to position "CIRC", connect the cable, fix the cable with a clamp.
V) Make sure the servo cable does not come off in both switch positions.
5. Install the electronic engine control unit.
6. Install the instrument panel assembly.
7. Install the A-pillar trim.
8. Connect a wire to the negative plug of the storage battery.