Note: Installation is carried out in the reverse order of removal.
1. Drain the oil from the gearbox housing.
2. Disconnect the cardan shaft from the gearbox.
a) Loosen the four threaded connections shown in the figure.
b) Place the rag as shown in the figure to avoid damaging the seal.
c) Using a brass rod and a hammer, remove the driveshaft
d) Unscrew the four mounting bolts and disconnect the propeller shaft.
Note: Secure the drive shaft.
The original publication can be found on the website (www.toyotaman.ru)
3. Disconnect the drive shafts from the gearbox.
Note: Secure the drive shafts.
4. Remove the rear beam.
4. Remove the gearbox.
a) Place a jack under the gearbox.
b) Unscrew the two rear support bolts.
- Tightening torque - 150 Nm
c) Unscrew the two bolts securing the front support.
- Tightening torque - 105 Nm
d) Unscrew the two bolts and remove the gearbox.
- Tightening torque - 130 Nm
Removal and installation the gearbox
1 - rear drive shaft,
2 - bushing,
3 - gearbox,
4 - drive shaft,
5 - cardan shaft,
6 - bolt,
7 - crossbar,
8 - gasket,
9 - exhaust pipe.