Removal air
1. Fill the reservoir with fresh brake fluid (use of waste liquid is prohibited).
2. Raise the car.
3. Remove the cap and put the hose on the cylinder nipple.
4. Place the other end of the hose into a container filled with 5 cm of brake fluid.
5. Ask an assistant to press the clutch pedal all the way down and unscrew the bleed screw.
6. When the liquid stops flowing, tighten the nipple.
7. Ask your assistant to slowly release the pedal.
8. Repeat the procedure until air bubbles stop coming out of the hose with the liquid. Constantly monitor the level – the tank should be filled with liquid.
9. Tighten the nipple, put on the cap and lower the car.
10. Restore the fluid level in the reservoir and check the operation of the clutch.