Pic. 3.41. Clutch accumulator
Remove the battery.
Remove air tube #1.
Removing
Disconnect the wiring harness bracket.
Using the SST tool, disconnect the 2 tubes connecting to the hoses.
Note. Substitute a suitable vessel to collect the liquid.
Turn away a bolt, 2 nuts and remove the hydroaccumulator of a drive of coupling.
Installation
Install clutch accumulator and secure with 2 nuts and bolt.
Tightening torque: 12 Nm.
Using SST, connect the two tubes connecting to the hoses to the clutch accumulator.
Tightening torque: 15 Nm.
Connect the wiring harness bracket.
Install air duct #1.
Install the battery.
Fill the master cylinder reservoir with brake fluid and bleed the clutch. Tightening torque: 8.4 Nm.
Check for fluid leakage in the clutch actuator