a) Remove the inner ring from the bearing.
b) Using a special tool and a press, install the new bearing into the steering knuckle.
c) Install the inner bearing ring.
2. Using a drift and hammer, install the new seal.
Apply grease to the lip of the seal.
3. Install the mudguard and tighten the three bolts.
- Tightening torque - 9 Nm
4. Using a special tool and a press, install the hub.
5. Using the special tool, install the new retaining ring.
6. Using a drift and hammer, install the new oil seal as shown in the figure.
7. Install the lower ball joint.
a) Install the lower ball joint and tighten the nut.
Caution: Before installation, clean the conical part of the ball joint pin and the hole in the steering knuckle from traces of grease and other contaminants.
- Tightening torque - 105 Nm
b) Install a new cotter pin.
Note: when installing the cotter pin, the nut can be turned at an angle of no more than 60°.
8. Using the special tool and a hammer, install the new boot.
Note: When installing, align the holes for the speed sensor (ABS) in the dust cover and in the steering knuckle.
(For models without ABS)
Install the new boot as shown in the figure.
