A) Install the drive shaft into the wheel hub.
Note: Be careful not to damage the driveshaft boots.
b) Align the alignment marks on the output shaft of the differential and the drive shaft.
V) Tighten the four fastening nuts.
- Tightening torque - 70 Nm
2. (Models with ABS)
Install the speed sensor.
- Fastening bolt tightening torque - 20 Nm
3. Tighten the locknut.
A) Close the locknut.
- Tightening torque - 220 Nm
b) Install cotter pin and locknut cap.
4. Install the wheel.
- The tightening torque of the mounting bolts is 105 Nm