The figure shows a top view of the position of the front wheels. In this case, dimension B is in front.
Before adjusting the wheels, remove the wire clamp from the protective cover so as not to damage the cover when turning the shaft. Loosen the locknut on the tie rod and adjust the wheel position by turning the tie rod end.
When adjusting, make sure that the position of the left and right wheels is the same, i.e. Both tie rod ends must turn out the same amount. The maximum difference in their length should not exceed 1.5 mm.
Tighten locknuts to 50 Nm. Fasten the protective covers with a wire clip.