Attention! Wear gloves to avoid cutting your hands on the edges of the technological windows in the door frame!
1. On models equipped with power windows and a single lock, disconnect the negative cable from the battery.
Attention! If the stereo system installed in the car is equipped with a security code, before disconnecting the battery, make sure that you have the correct combination to activate the audio system!
2. Remove the door trim panel and moisture barrier film (see Section Removal and installation of panels of an internal upholstery of doors).
3. Remove window glass (see Section Removal and installation of door glasses).
4a. On models with manual power windows...
4b.... remove the five fixing bolts (refer to accompanying illustrations).
4c. To remove the electric drive regulator, disconnect the wiring and unscrew the six mounting bolts (refer to accompanying illustration) (Except rear window regulator).
5. To remove the power window regulator of the rear door, remove the latch of the lock and the outer door handle (see Section Removal and installation of latches, lock cylinders and door handles), then disconnect the relevant electrical wiring and remove the four fixing bolts (refer to accompanying illustration). Remove the regulator assembly from the door frame.
6. Installation is carried out in the reverse order. Remember to lubricate the rollers of the regulators with multipurpose grease. Track the reliability of tightening and snapping fasteners.