Tailgate design
1 - Window regulator; 2 - Right window guide; 3 - Door stop; 4 - Rear glass; 5 - Left guide window; 6 - Door lock; 7 - Guide tape facing the window opening; 8 - External sealing tape; 9 - Service hole cover; 10 - Plate; 11 - Latch drive crank; 12 - Lock cylinder; 13 - Internal sealing tape; 14 - Facing panel of the license plate; 15 - Back door upholstery panel
1. Disconnect the negative cable from the battery.
Attention! If the stereo system installed in the car is equipped with a security code, before disconnecting the battery, make sure that you have the correct combination to activate the audio system!
2. If desired, the tailgate can be removed from the car (see Section Removal, installation and adjustment of the tailgate).
3. Remove the hinged handrail handle of the tailgate by removing its panel and unscrewing the mounting bolt.
4. Release ten clips of fastening of the panel of an internal upholstery of a door. Disconnect the electrical wiring and remove the screws securing the service hole cover (refer to illustration above).
5. Remove the guide tape facing the rear window opening.
6. Disconnect the remaining electrical wiring, remove the glass and remove the power window regulator assembly (refer to accompanying illustration).
7. Installation is carried out in the reverse order.