Vehicle check
1. Check the tightness of the service window, fusible plug and receiver connections.
2. If any problems are found, make the necessary repairs.
Removing
1. Remove the refrigerant from the system.
2. Disconnect the two tubes from the receiver.
Note: Plug the open ends of the tubes immediately.
3. Remove the receiver from the bracket.
Installation
1. Install the receiver on the bracket. Attention: remove the plugs only immediately before connecting the pipes.
2. Connect tubing to receiver. Tighten the tubes.
Tightening torque - 13 N.m
3. Install the battery.
4. If the receiver has been replaced, add 20 ml to the compressor. compressor oil.
5. Vacuum, prime and check the system for leaks.