Removing
1. Pump out a syringe a brake liquid from a tank.
Caution: Do not allow brake fluid to come into contact with painted surfaces. If brake fluid comes into contact with a painted surface, wash it off immediately.
2. Disconnect the brake fluid low sensor connector.
3. Using the special tool, disconnect the brake pipes from the master brake cylinder.
Removing the brake master cylinder
1 - tee,
2, 6, 8, 9 - brake pipes,
3 - master brake cylinder,
4 - gasket,
5 - vacuum brake booster,
7 - bracket (2C).
Models without ABS
Models with ABS
4. Turn away nuts of fastening, remove the main brake cylinder and a lining.
Models without ABS
Models with ABS
Installation
1. Installation is made in the reverse order of removal.
5. Fill the reservoir with brake fluid and bleed the brake system.
6. Check for leaks.
7. Check and adjust the brake pedal.