Note: after adjusting the camber, check the amount of toe-in of the front wheels.
1. Remove the front wheels.
2. Loosen the two nuts on the underside of the rack.
3. Adjust the camber by moving the bottom of the strut.
Note: When using an unmarked bolt, camber adjustment is possible between 0°06' and 0°30'.
4. Tighten the bolts.
- Tightening torque - 240 Nm
Table. Front camber adjustment
5. Install the front wheels.
- Tightening torque - 105 Nm
6. Check the camber.
If the camber does not meet the specified conditions, then, using the table, select the bolt and adjust.
7. Turn away two nuts from the bottom party of a rack.
Attention:
- In the case when the camber differs from the specified value by less than 45', then the upper bolt can not be replaced.
- In the case when the camber differs from the specified value by more than 45', then the upper bolt must be replaced with a bolt with a minimum diameter.
8. Using the table, select the bolt and make the adjustment.
Note: If both bolts are being replaced, do not remove them at the same time.