2. Turn away a bolt of fastening of a brake hose.
3. Turn away bolts of fastening of a wire of the sensor of frequency of rotation and the sensor.
4. Disconnect a rack from a rotary fist, having turned away bolts and nuts.
5. Loosen the strut nut.
6. Turn away three nuts and remove a rack in gathering.
6. Remove the spring.
A) Install the bolt and two nuts on the bracket at the bottom of the stand and secure it in a vise.
b) Install the special tool on the spring as shown in the figure.
V) Using the special tool, compress the spring.
Attention: when compressing the spring, do not hook the special tool on the lower and upper coils of the spring. Also, be careful not to damage the lower spring seat.
G) Remove the nut and remove: upper strut support, dust seal, upper spring seat, upper vibration isolator, spring, compression travel stop, lower vibration isolator.
Shock absorber check
Pulling and sinking the shock absorber rod, check that its stroke is smooth and there is no extraneous resistance or noise.
If defective, replace shock absorber.