Contents: Examination ↓ Replacement ↓ Replacing the ignition switch ↓ Replacing the switch (drum) of the…↓
FJ60 Ignition Switch Test Diagram
FJ62 Ignition Switch Test Diagram
FJ80 Ignition Switch Test Diagram
Examination
1. Disconnect the ignition switch connector by locating it along the wires.
2. Use an ohmmeter or test lamp to check for a circuit between the specified terminals in different key positions. Replace the lock if the results of at least one of the tests are negative.
Replacement
1. Disconnect the battery from ground.
2. Turn the key to the ACC position.
3. Remove the steering wheel.
4. Remove the steering column cover.
5. Remove the switch combination from the steering shaft.
Replacing the ignition switch
6. Disconnect the wire connectors.
7. Loosen the mounting screws and remove the lock.
8. Installation is carried out in reverse order.
Replacing the switch (drum) of the lock
[The original is this website ToyotaMAN.ru]
9. On some vehicles, remove the lock illumination ring.
10. Press the pin in and remove the lock by pushing it upwards.
11. When installing the lock, press the pin and insert the lock into the hole until the pin locks into place.
12. Then assembly is carried out in reverse order.