2. Disconnect the longitudinal steering rod from the steering knuckle, having first removed the cotter pin and unscrewed the nut.
3. Disconnect the steering arm from the steering gear.
Installing the bipod
1. Align the marks on the steering knuckle and the steering shaft.
2. Connect the tie rod to the steering knuckle and tighten the nut. Then install a new cotter pin.
Steering drive.
1 - Steering knuckle arm,
2 - Plug,
3 - Clamp,
4 - Steering rod assembly,
5 - Pendulum lever,
6 - Central steering rod,
7 - Bipod,
8 - Longitudinal steering rod,
9 - Central lever
Steering drive.
1 - Bipod,
2 - Longitudinal steering rod,
3 - Wheel brake cylinder,
4 - Steering knuckle arm,
5 - Steering rod assembly,
6 - Clamp.
- Tightening torque - 91 Nm
3. Install the bipod and tighten the bipod mounting nut.
Tightening torque:
- DYNA — 177 Nm
- DYNA — 172 Nm
4. Check the steering wheel center position.