Remove the #1 motor bottom guard.
Removing
Disconnect the knock sensor connector.
Pic. 2.566. Removing the knock sensor
Loosen the retaining nut and remove the knock sensor (pic. 2.566).
Installation
Secure the knock sensor with a nut.
Tightening torque: 20 Nm.
Pic. 2.567. Installing the knock sensor
Note. Make sure the knock sensor is installed at the correct angle (pic. 2.567).
Connect the knock sensor connector.
Connect the negative terminal to the battery terminal.
Tightening torque: 5.4 Nm.
Install the #1 engine bottom guard.