Pic. 3.37. Clutch travel sensor location
Disconnect the negative terminal from the battery terminal.
Removing the clutch travel sensor
Pic. 3.38. Clutch travel sensor connector
Disconnect the clutch travel sensor connector (pic. 3.38).
Note. Do not pull hard on the connector as this may damage the wires.
Pic. 3.39. Clutch stroke sensor mounting
Remove the 2 screws and remove the clutch travel sensor from the clutch actuator (pic. 3.39).
Remove the O-ring.
Installing the Clutch Travel Sensor
Lubricate the new O-ring with multipurpose grease.
Install the O-ring on the clutch travel sensor.
Pic. 3.40. Scheme of the correct installation of the clutch travel sensor
Establish the gauge of a course of coupling so that ledge from the gauge and ledge from the drive were located, as shown in an illustration 3.40.
Turn the clutch travel sensor clockwise and secure with two screws.
Connect the clutch travel sensor connector.
Connect the negative terminal to the battery terminal.
Initialize the MMCP ECU.
Set up MMCP.
Calibrate the timing positions.