Pic. 3.22. Clutch Master Cylinder
Remove the windshield wiper arm cover.
Remove the left windshield wiper arm with brush assembly.
Remove the right windshield wiper arm with brush assembly.
Remove the upper edge seal of the engine compartment bulkhead.
Remove the top left air vent fairing.
Remove the top right air vent fairing.
Remove draft of a screen wiper in gathering.
Remove the top outer hood panel.
Remove clutch fluid.
Note. Spilled hydraulic fluid must be washed off immediately to prevent damage to paintwork.
Remove the master brake cylinder.
Disconnecting the flexible hose from the clutch master cylinder reservoir
Pic. 3.23. Flexible Hose Clamp
Loosen the clamp and disconnect the flexible hose from the clutch master cylinder (pic. 3.23).
Note. Substitute a suitable vessel to collect the liquid.
Disconnection from the clutch master cylinder of the tube connecting it to the hose
Pic. 3.24. Disconnection from the clutch master cylinder of the tube connecting it to the hose
Disconnect the tube connecting the master cylinder to the hose using the special tool (pic. 3.24).
Removing the pusher fork of the clutch master cylinder with the axle
Remove the cotter pin and axle.
Removing the clutch master cylinder
Loosen the 2 nuts and remove the clutch master cylinder and gasket.
Clutch master cylinder installation
Install clutch master cylinder assembly and new gasket and secure with 2 nuts. Tightening torque: 12 Nm.
Note. Install other components in the reverse order of removal.