Contents: Examination ↓ Replacement ↓
Engine mount components generally do not require maintenance, however, if damage to the engine mounts or signs of aging are detected, they should be replaced immediately.
Examination
1. Raise the vehicle and support it on jack stands, then place a jack stand under the engine oil pan. Place a large board between the pan and the jack stand and carefully lift the engine to relieve the weight on the jack stands. Do not place a board under the oil pan drain plug.
 |  |
2. Check the supports for cracks, hardening or delamination from the metal base (left support - photo on the left, right support - photo on the right).
3. Check if the support plates move relative to the engine (to do this, rock the supports with a crowbar or a large screwdriver). If movement is felt, lower the engine and tighten the mounts.
4. To slow down aging, lubricate the rubber parts of the supports with a preservative.
The original is this website: ToyotaMAN.ru
Replacement
1. Disconnect the battery from ground, lift the car and place it on stands.
2. To remove the right support, unscrew the nuts from below and 1 bolt from above, remove the upper section of the support from the engine bracket.
3. Loosen the nuts securing the support to the chassis and remove the support.
4. To remove the left support, unscrew the nut and bolt, separate the lower and upper supports.
5. Loosen the bolts of the support cushions on the cylinder block and chassis, remove the supports.
6. Installation is carried out in the reverse order. Lubricate the threads of the nuts and bolts with a locking compound and tighten securely.