Oil Cooler Installation Components
1 - Oil cooler cover; 2, 4, 6 - Gasket; 3 - Check valve; 5 - Oil cooler; 7 - Probe; 8 - Filter; 9 - Probe tube; 10 - Tube seal; 11 - Cork; 12 - Washer; 13 - Spring; 14 - Safety valve; 15 - Safety valve housing; 16 - Drain plug
1. Drain the coolant and remove the oil filter
2. Remove a gear belt and a gear wheel of TNVD.
3. Remove the injection pump.
4. Remove the dipstick and remove its guide.
5. Give fixture and remove assembly of an oil cooler.
6. Unscrew the ECT sensor if necessary.
7. Give 4 nuts and separate a cover from an oil cooler.
8. Remove relief and check valves.
9. Installation is carried out in the reverse order. Tighten fasteners to the required torque.