Removing
Attention! Work is carried out on a cold engine.
1. Disconnect the battery from the ground.
2. Disconnect all connectors from the camera.
3. Disconnect the throttle cable and transmission linkage.
4. Remove the oil gauge pipe bracket.
5. Clearly label and disconnect all vacuum hoses.
6. Disconnect the crankcase ventilation hose.
7. Loosen the bolt and remove the bracket (if provided).
8. Disconnect and plug coolant hoses.
9. Loosen the screws and remove the camera.
Installation
1. Clean and check the condition of the manifold and chamber split planes. Replace the lower intake manifold gasket. Install the chamber assembly with the damper body on the intake manifold. Make sure the gasket is installed correctly.
2. Wrap bolts of fastening to an inlet manifold, tighten bolts with the moment specified in (see subsection 3.2.1). Further installation is carried out in the reverse order.