Removing
1. Disconnect the battery from the ground.
2. Loosen the cable end locknuts on the damper body.
3. Turn the throttle lever and remove the cable by passing it through the groove in the lever.
4. Disconnect the cable from the pedal. Loosen the mounting bolts (indicated by arrows) cable sheath bracket to the bulkhead of the engine compartment.
5. Pull the cable through the engine compartment.
Installation and adjustment
1. The cable is installed in reverse order. Make sure that the through cable sheath seal is installed correctly in the bulkhead of the engine compartment.
2. To adjust the cable, fully depress the pedal with the throttle fully open. If the damper does not open completely, then loosen the locknuts, press the pedal to the full and, with the damper fully open, tighten the locknuts.
3. Check adjustment. When the pedal is released, the damper should close completely.