Note: Install in the reverse order of removal.
1. Wash the outer surfaces of the gearbox housing.
2. Unscrew the drain plug in the gearbox pan and drain the working fluid into a suitable container.
- Tightening torque - 18 Nm
Loosen the pan mounting bolts. Remove the pan and gasket.
Note: Some liquid always remains in the tray. Do not damage the filler tube and sealing ring.
- Tightening torque - 5 Nm
Installation instruction: Fix the magnets to the transmission pan as shown in the figure.
A241L, A241E
A245E before 1994.
A245E since 1994.
4. (A241L)
Disconnect the overdrive solenoid valve connector.
5. (A241E)
Disconnect the three solenoid valve connectors.
The material is reprinted from an online resource toyotaman.ru
6. (A245E)
Remove the filter.
7. (A245E since 1994.)
Disconnect the solenoid valve connectors.
6. Disconnect the throttle valve control cable.
a) Disconnect the cable from the cam in the gearbox.
b) Loosen the cable mounting bolt and remove the cable.
- Tightening torque - 5.5 Nm
Installation instructions: If the cable is new, install the stopper on the inner cable.
a) Bend the cable so that the bending radius is about 200 mm.
b) Pull the inner cable until a slight resistance appears. Hold it in this position.
c) Install the stopper at a distance of 0.8-1.5 mm from the end of the outer shell, as shown in the figure.
Note: After installation, adjust the throttle control cable.