Replacing front brake hoses
1. Raise the car and remove the wheel.
2. Unscrew the tube fitting from the hose.
3. Remove the bracket (2) and pass the hose (3) through the hole in the bracket (1 – tube).
4. Loosen the fitting bolt and disconnect the hose from the caliper.
5. When reassembling, replace the copper washers, align the protrusion on the hose with the hole in the caliper, and tighten the fitting bolt to the specified torque.
6. Pass the hose through the bracket, screw on the fitting nut, insert the clamp and tighten the nut.
7. Remove air from the caliper cylinders (see subsection 8.10).
8. Install the wheel and lower the vehicle.
Replacing rear brake hoses
1. Follow steps 1–3.
2. Remove air from the caliper cylinder (see subsection 8.10).
Replacement of tubes
1. When replacing pipes, make sure that they are secured with clamps along the entire route.
2. The shape of the curved new tubes must match the shape of the replacement ones.
3. Only steel tubes that exactly match the vehicle make are allowed to be installed.
The article is taken from a web resource: www.ToyotaMAN.ru