Removal and installation
1. Loosen the nuts (indicated by arrows) axle shaft flange and remove the washers.
2. Strike the axle shaft stud through the brass mandrel to loosen the conical washers and remove them from the hub.
3. Screw 2 bolts into the technological holes of the flange and, turning, displace the axle shaft from the hub. Remove the half shaft.
4. Look at the axle shaft.
5. Remove the seal if necessary.
6. Before installing the axle shaft, lightly grease the lips of the oil seal with grease.
7. Before assembly, clean the surface and replace the flange gasket.
8. Insert the axle shaft and insert the differential gears into the splines.
9. Further assembly is carried out in the reverse order.