Engines 2L, 2L-T, 3L
1. Put the oil pump body (timing belt cover) on wooden stands.
Attention: you should choose the height of the supports so as not to damage the TDC indicator.
2. Install the drive and driven gears.
A) Place the drive and driven gears in the oil pump housing with the marks facing up.
b) Apply adhesive to two or three screw threads.
V) Install the pump housing cover by tightening the six screws.
Tightening torque - 10 N.m
2. Install pressure reducing valve.
A) Insert the valve and spring into the timing belt housing mounting hole.
b) Using a hex wrench (12 mm), install a new gasket and plug.
Tightening torque - 37 N.m
Engine 1KZ-T
1. Installation of pressure reducing valve
A) Place the valve and valve spring into the timing belt cover
b) Install a new gasket and tighten the plug to 42 Nm.
2. Install the pinion