Pic. 3.120. Pressing in a new pump seal
Using special tool 09350-32014 (09351-32140) and a hammer, install a new pump seal (pic. 3.120).
Note. Lubricate the lip of the oil seal with Vaseline before installation. The oil seal must be flush with the outer edge of the oil pump.
Pic. 3.121. Installing the oil pump housing O-ring
Lubricate the o-ring with automatic transmission fluid, install it in the oil pump housing (pic. 3.121).
Pic. 3.122. Installing the oil pump front driven gear
Lubricate the front driven gear of the oil pump with automatic transmission fluid, install it in the oil pump housing with the mark up (pic. 3.122).
Pic. 3.123. Installing the oil pump front drive gear
Lubricate the front drive gear of the oil pump with automatic transmission fluid, install the gear in the oil pump housing with the mark up (pic. 3.123).
Pic. 3.124. Installing the stator shaft
Install the stator shaft by aligning the mounting bolt holes. Using a Torx socket wrench (T30), install and tighten the 11 mounting bolts (pic. 3.124).
Tightening torque: 9.8 Nm.
Pic. 3.125. Installation of sealing rings of the clutch drum
Install 2 new clutch drum O-rings (pic. 3.125).
Attention! Do not over-expand the gap between the ends of the rings.
Check the oil pump, to do this, turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.