Share information:
Wheels and tires of the car Toyota Camry 3 (XV30)
Checking the height of the tread pattern
Check the degree of tire wear and measure the tire pressure. Depending on the configuration and operating conditions, see the maximum pressure data for cold tires in summary table 4.1. The lower the tread depth, the...
Check the degree of tire wear and measure the tire pressure. Depending on the configuration and operating conditions, see the maximum pressure data for cold tires in summary table 4.1. The lower the tread depth, the...
Tire replacement
When replacing tires, use only tires of the same size and design, with the same tread pattern and with an equivalent or greater load-carrying capacity. Using a tire of any other size or type may seriously affect...
When replacing tires, use only tires of the same size and design, with the same tread pattern and with an equivalent or greater load-carrying capacity. Using a tire of any other size or type may seriously affect...
Measuring the clearance of the front and rear wheels of a car
Fig. 4.4. Scheme for measuring the clearance of the front and rear wheels of a car Measure the clearance of the rear and front wheels according to the diagram shown in Figure 4.4. If the clearance value does not...
Fig. 4.4. Scheme for measuring the clearance of the front and rear wheels of a car Measure the clearance of the rear and front wheels according to the diagram shown in Figure 4.4. If the clearance value does not...
Checking and adjusting wheel alignment angles
Examination Fig. 4.5. Wheel alignment check diagram Check the wheel alignment angles (Fig. 4.5). If the toe angles do not correspond to the specified values, make adjustments. Convergence: A+B = 0°±0.2°; C–D = 0±2 mm....
Examination Fig. 4.5. Wheel alignment check diagram Check the wheel alignment angles (Fig. 4.5). If the toe angles do not correspond to the specified values, make adjustments. Convergence: A+B = 0°±0.2°; C–D = 0±2 mm....
Checking and adjusting wheel angles
Fig. 4.7. Wheel turning angle check diagram Check the wheel turning angles (Fig. 4.7). If the wheel turning angles differ from the standard, then it is necessary to make sure that the lengths of the left and right...
Fig. 4.7. Wheel turning angle check diagram Check the wheel turning angles (Fig. 4.7). If the wheel turning angles differ from the standard, then it is necessary to make sure that the lengths of the left and right...
Checking the camber, longitudinal and transverse tilt of the steering axes
Fig. 4.8. Checking the wheel alignment: 1 – test stand; 2 – sensor Check the camber of the front wheels, longitudinal and transverse tilt of the steering axes (Fig. 4.8). The longitudinal and transverse tilt of the...
Fig. 4.8. Checking the wheel alignment: 1 – test stand; 2 – sensor Check the camber of the front wheels, longitudinal and transverse tilt of the steering axes (Fig. 4.8). The longitudinal and transverse tilt of the...
Wheel alignment
Caution: After adjusting the camber, check the front wheel toe-in angle again. Remove the front wheels and the speed sensor clamp (ABS). Fig. 4.9. Lower side of the rack mounting nuts Unscrew the two mounting nuts from...
Caution: After adjusting the camber, check the front wheel toe-in angle again. Remove the front wheels and the speed sensor clamp (ABS). Fig. 4.9. Lower side of the rack mounting nuts Unscrew the two mounting nuts from...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Link in different formats to this article
TEXTHTMLBB Code
- User manual
- Vehicle description
- Keys, locks and alarms
- Governing bodies
- Salon equipment
- Driving and operation
- Maintenance
- Power unit
- 4-cylinder engine
- Control system (I4)
- Engine overhaul (I4)
- 6-cylinder engine
- Control system (V6)
- Engine overhaul (V6)
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive mechanism
- Chassis, running gear
- Wheels and tires
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Doors, locks and windows
- Air conditioning and heater
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits
- General information
- Controls and instruments
- Driving and operation
- Daily care
- Maintenance
- Power unit
- 4-cylinder engine
- 6-cylinder engine
- Engine overhaul
- Engine electrical equipment
- Cooling system
- Heating and ventilation
- Fuel system
- Exhaust system
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch
- Chassis, running gear
- Suspension and axle shafts
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- 4-cylinder engine
- 6-cylinder engine
- Overhaul of engines
- Cooling and heating
- Fuel system
- Engine electrical equipment
- Control system
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- Chassis, running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Petrol engines
- Diesel engines
- Engine overhaul
- Cooling and lubrication system
- Fuel system (diesel)
- Fuel injection (petrol)
- Engine electrical equipment
- Transmission
- Clutch and cardan
- Automatic gearbox
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body elements
- Air conditioning and heater
- SRS security system
- Electrical equipment
- Equipment and devices
- Electrical circuits