Vehicle drive mechanism Toyota Camry 3 (XV30)

Drive mechanism — general information
The drive shafts transmit torque from the engine, gearbox and differential to the front wheels. In the gearbox housing, the drive shafts are secured with splined connections to the differential axle gears. The splined...

Check on the car
Remove the front wheel. Remove the front left disc brake caliper. Remove the front disc. Using a dial indicator, check the clearance near the center of the wheel hub. Maximum: 0.05 mm. If the clearance exceeds the...

Drive Mechanism Components
Fig. 3.135. Front wheel drive components (part 1): 1 – right front wheel drive assembly; 2 – retaining ring of the drive shaft bearing; 3 – Left front wheel drive assembly; 4 – lower arm of front suspension No.1 left,...

Repair of the hub and steering knuckle of the front wheel
Attention! The repair operations for the hub and steering knuckle of the left and right front wheels are the same. Removal Remove the front wheel. Using special tool 09930-00010, loosen the front wheel hub nut....

Replacing the front wheel hub bolt
Remove the front wheel. Remove the front disc brake caliper. Remove the front disc. Fig. 3.149. Removing the hub bolt Using special tool 09628-10011 and a screwdriver or pry bar to hold the hub, remove the hub bolt...

Removal and installation the rear wheel hub
Removal Remove the rear wheel. Fig. 3.151. Disconnecting the rear flexible hose Loosen the bolt and disconnect the rear flexible hose (fig. 3.151). Fig. 3.152. Removing the disc brake caliper Remove 2 bolts and disc...

Removal and installation the rear wheel hub steering knuckle
Removal Remove the rear wheel. Remove the rear suspension strut assembly. Disconnect the disc brake caliper. Remove the rear disc. Disconnect the skid control sensor wire. Remove the rear wheel hub. Fig. 3.155. Bolt for...

Replacing the rear wheel hub bolt
Remove the rear wheel. Disconnect the disc brake caliper. Remove the rear disc. Fig. 3.161. Removing the hub bolt Using special tool 09628-10011 and a screwdriver or pry bar to hold the hub, remove the hub bolt (fig....

Disassembling the front wheel drive
Drain the automatic transmission fluid (automatic transmission). Drain the oil from the manual transmission in the block with the main gear (manual transmission). Remove the front wheel. Fig. 3.163. Disconnecting the...

Checking the front wheel drive assembly
Check the front wheel drive assembly. Make sure there is no significant play in the outer joint. Make sure that the inner joint moves smoothly in the axial direction. Make sure there is no significant radial play in the...

Disassembling the front wheel drive
Fig. 3.173. Removing the inner hinge boot clamp Using a screwdriver, remove the inner hinge boot clamps (fig. 3.173). Remove the inner hinge cover. Fig. 3.174. Applying mounting marks to the tripod, shaft and hinge...

Removal the damper of the left front wheel drive (manual transmission)
Using a screwdriver, remove the damper clamp. Remove the front wheel drive damper. Using a screwdriver, remove the damper clamp. Remove the front wheel drive damper (except for 1MZ-FE engine). Using a screwdriver,...

Table of signs of drive mechanism malfunctions
Table 3.8. Table of signs of drive mechanism malfunctions

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Link in different formats to this article

TEXTHTMLBB Code