Vehicle owner's manual Toyota Vista 4 (V40)

Vehicle identification
Vehicle Identification Number (VIN) and Identification Plate The body number (VIN) and identification plate are located on the engine compartment partition A - Body number, B - Identification plate Engine number The...

General repair instructions
1. Use fender covers, seat covers and floor mats to protect your vehicle from dirt and damage. 2. When disassembling, arrange the parts in the proper order to facilitate subsequent assembly. 3. Observe the following...

Garage jack and lift paw mounting points
- garage jack installation points. - points for installing stands. - the center of mass of the car. Installation points of the lift dads.

Control and measuring instruments and controls
1. Brake system status indicator. a) The indicator lights up if parking brake on; low brake fluid level or brake booster leak; the electrical circuit of the indicator is faulty. b) If the indicator lights up while...

Anti-lock braking system (ABS)
Caution: Use tires of the same size, construction and load capacity as the original vehicle tires, as using a different type of tire may interfere with the proper operation of the anti-lock braking system (ABS). 1....

Traction Control (TRC)
1. The traction control system (TRC) is designed to automatically prevent wheel slip during acceleration and driving on slippery surfaces, and ensures stable vehicle control. However, it should be borne in mind that on...

4WS system
The 4WS system is designed to improve vehicle control. Depending on the vehicle's speed, the system works as follows: when driving at "low speeds", when the position of the front wheels changes, the rear wheels turn in...

Driving a car with automatic transmission
To control the automatic transmission, a selector is installed on the central console, to the driver's side. The selector is connected to the valve block by a cable, and can be used to set the range of gears used. To...

Features of the transmission of 4WD models
Caution: To avoid damage to transmission components, partial loading is prohibited for 4WD models (by raising only one of the vehicle's axles). 4WD vehicles have permanent all-wheel drive, the so-called "Full time 4WD"...

Tips for driving in different conditions
General recommendations Attention: Before driving, make sure that the parking brake is fully released and the corresponding indicator is off. Do not keep your foot on the brake pedal while driving. This can lead to...

Towing a car
Attention: it is strictly forbidden to tow 4WD vehicles using the partial loading method, i.e. with one of the vehicle axles raised. Note: towing of cars with automatic transmission is permitted at a speed of no more...

Starting the engine
Caution: Do not allow the engine to run at high speed for a long time or accelerate sharply when the engine is not warmed up. Before launch 1. Apply the parking brake. 2. Turn off unnecessary lights and auxiliary...

Engine Stop (Turbocharged Models)
Do not turn off the engine immediately after finishing the trip (especially after high speed or off-road driving). Let the engine idle for one to two minutes to cool the turbo. This will significantly extend the life of...

Wheel replacement
1. If you need to change a tire on the road, gradually reduce speed and move the car to a safe place. 2. Stop the vehicle on a level place with firm ground. 3. Stop the engine and turn on the hazard warning lights. 4....

Checking tire pressure and condition
1. Check your tires regularly for damage. Check your tire pressure every two weeks or at least once a month. Don't forget to check the pressure in your spare tire. The recommended TOYOTA tire pressure for your vehicle...

Tire replacement
1. When replacing tires, use only tires of the same size and design as those originally installed, and with the same or greater load capacity. Using a tire of any other size or type may seriously affect handling,...

Features of using aluminum wheels
Caution: To avoid damaging the protective varnish layer, do not allow tire shop workers to clean the outer surface of the rim with a wire brush or remove adhesive balancing weights with a screwdriver when replacing...

Replacement of wheel disks
1. Due attention should be paid to replacing wheel rims. Make sure that rims with the same load capacity, diameter, rim width and offset are installed. 2. Incorrect selection of wheels and tires can adversely affect...

Brake lining wear indicators
Disc brake pads are equipped with wear indicators in such a way that when driving, when the thickness of the pads is minimal, the wear indicator touches the brake disc and the brakes make an unpleasant sound ("squeal").

Catalytic converter and exhaust system
1. The catalytic converter is a device for reducing the toxicity of exhaust gases. When operating a vehicle equipped with a catalytic converter, observe the following precautions: a) During and after engine operation,...

Checking and replacing fuses
Note: If the headlights or other electrical components do not work, check the fuses. If any of the fuses are blown, they must be replaced. 1. Turn off the ignition. 2. The figure below shows the location of the fuses in...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ User manual Toyota 4Runner N120 (1989-1995)
➥ User manual Toyota RAV 4 XA10 (1994-2000)
➥ User manual Toyota Corona T190 (1992-1997)
➥ User manual Toyota Carina T190 (1992-1996)
➥ User manual Toyota Duet (1998-2004)
➥ User manual Toyota Corolla E80 (1983-1990)

Link in different formats to this article

TEXTHTMLBB Code