Attention! After adjusting the camber, check the toe angle of the front wheels again.
Remove front wheels and speed sensor clamp (ABS).
Pic. 4.9. Nuts of fastening of the bottom party of a rack
Loosen the two nuts on the underside of the rack (pic. 4.9).
Apply engine oil to the nut threads.
Temporarily install nuts.
Pic. 4.10. Camber adjustment scheme
Adjust the camber by moving the bottom of the strut (pic. 4.10).
Set the average camber value. When using a bolt without a mark, the adjustment of the camber is possible in the range from 0°06' to 0°30'.
Tighten nuts.
Tightening torque: 211 Nm.
Install the front wheels.
Tightening torque: 103 Nm.
Check collapse.
If the camber does not meet the specified conditions, then using table 4.5, select the bolt and adjust.