Exterior (external body elements) Toyota Camry 1 (XV10)

The car has a load-bearing body. The bodywork is made from forged and welded parts, including front and rear crumple zones and a rigid center section.

Safety precautions when performing welding work
When performing welding or other work involving strong sparks near the location of the battery, be sure to remove the battery. It is prohibited to weld or solder parts of a filled air conditioner. This also applies to...

Car body care and washing
Attention! After washing the car, the effectiveness of the brakes decreases due to humidity. It is recommended to dry the brake discs by briefly pressing the brake pedal at the start of movement. The condition of the...

Repair of minor body damage
Treatment of car body scratches If the scratch is superficial and does not reach the metal, rub the area around the scratch with paint renewer or fine-grained abrasive paste. Rinse the surface with clean water. Apply a...

Repair of severe body damage
In case of significant damage to the body and the need to replace a significant part of the parts, the work must be carried out at a maintenance station. If the body damage is the result of a strong impact, it is...

Hood — removal and installation
Removal 1. Open the hood and support it in this position. 2. Using a marker, mark the position of the hinges on the hood. 3. Place a clean rag under the corners of the hood to protect the vehicle's paint when removing...

Front bumper — removal and installation
Front bumper and its fastening elements 1 – radiator grille; 2 – headlights; 3 – front direction indicator; 4 – lower retainer; 5 – turn signal indicator light; 6 – bumper cover; 7 – bumper retainer; 8 – side bumper...

Rear bumper — removal and installation
The rear bumper and its mounting elements on cars with a "sedan" body 1 – backlight; 2 – side bumper mount; 3 – Upper bumper retainer; 4 – air duct; 5 – bracket; 6 – bracket; 7 – bumper reinforcement; 8 – Bumper energy...

Exterior rear view mirrors
Location of electrical connector and mounting bolts for outside rear view mirror A – electrical connector 1. Using a screwdriver as a lever, remove the inner decorative trim of the mirror. 2. Disconnect the electrical...

Radiator grille — removal and installation
1. Unscrew the upper radiator grille mounting bolts. 2. Lift the radiator grille up and remove it from the vehicle. 3. Installation is carried out in the reverse order of removal.

Engine Mudguard — Removal and Installation
1. Raise the front of the vehicle and support it on stands. 2. Unscrew the mounting bolts, lower the engine splash guard down and remove it from under the vehicle. 3. Installation is carried out in the reverse order of...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Exterior (external elements) Toyota RAV 4 XA10 (1994-2000)
➥ Exterior (external elements) Toyota Carina T190 (1992-1996)
➥ Exterior (external elements) Toyota Cruiser 100 (1998-2007)
➥ Exterior (external elements) Toyota 4Runner N120 (1989-1995)
➥ Exterior (external elements) Toyota Corolla Verso 3 (2004-2009)
➥ Exterior (external elements) Toyota Highlander 1 (2000-2007, petrol)

Link in different formats to this article

TEXTHTMLBB Code