Examination
Pic. 4.5. The scheme of checking the angles of convergence of the wheels
Check wheel alignment (pic. 4.5).
If the angles of convergence do not correspond to the specified values, make an adjustment.
Convergence:
- A + B \u003d 0°± 0.2°;
- C–D = 0±2 mm.
Adjustment
Remove the cover clamps.
Loosen the tie rod end nuts.
Pic. 4.6. Wheel alignment
Adjust the toe angle by turning the left and right tie rods the same number of turns (pic. 4.6).
Try to set the average value of the angle of convergence. Make sure that the lengths of the right and left links are the same.
Rod length difference: less than 1.5mm.
Tighten the tie rod end nuts.
Tightening torque: 74 Nm.
Install the covers and secure them with clamps.
Attention! Make sure the covers are not twisted.