Gasoline engines 3S/4S-FE car Toyota Vista 4 (V40)

Description of petrol engines 3S-FE (2.0), 4S-FE (1.8)
Engines 3S-FE, 4S-FE are in-line 4-cylinder, 16-valve with overhead camshafts. Cylinder numbering is carried out from the crankshaft pulley. Engine firing order: 1-3-4-2. The crankshaft is 5-bearing with 8...

Removal the timing belt
1. Remove the right engine mount support by unscrewing the three bolts. 2. Remove the generator. a) Disconnect the wire harness clamp from the clamp on the generator. b) Disconnect the generator connector. c) Remove the...

Installing the timing belt
1. Install the oil pump pulley if removed. a) Align the pulley and shaft profiles and install the pulley. b) Tighten the oil pump pulley mounting nut Tightening torque - 28 Nm 2. Install the crankshaft timing pulley....

Removal the cylinder head
Note: The cylinder head removal procedures are given using the 3S-FE engine as an example. For the 4S-FE engine, the attachment removal procedure may be slightly different. 1. Disconnect the negative terminal from the...

Installing the cylinder head
1. Install the cylinder head onto the cylinder block, after installing a new cylinder head gasket. 2. Install the cylinder head mounting bolts. Note: The cylinder head mounting bolts are tightened in two stages. If any...

Cylinder block — operations before disassembly
1. Remove the flywheel (models with manual transmission) or torque converter drive plate (models with automatic transmission). Note: Before removing the flywheel or torque converter drive plate, place marks to avoid...

Cylinder Block: Final Assembly
1. Install the knock sensor. Tightening torque - 37 Nm 2. (Models with oil cooler) Install the oil cooler. a) Clean the contact surface of the oil cooler and cylinder block. b) Install a new O-ring and gasket onto the...

Disassembling the cylinder head
Disassembling the cylinder head. 1 - cylinder head cover, 2 - sealing of spark plug tubes, 3 - spark plug, 4 - gasket, 5 - adjusting washer, 6 - pusher, 7 - crackers, 8 - valve spring plate, 9 - valve spring, 10 - oil...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Engines 5E-FE Toyota Corona T190 (1992-1997)
➥ Petrol engines 1.3 l Toyota Duet (1998-2004)
➥ 6-cylinder engines Toyota 4Runner N120 (1989-1995)
➥ Engine repair Toyota Corolla E80 (1983-1990)
➥ Engine adjustment Toyota Cruiser 70 (1985-1996, diesel)
➥ 4-cylinder engine Toyota Highlander 1 (2000-2007, petrol)

Link in different formats to this article

TEXTHTMLBB Code