Car clutch repair Toyota Camry 2 (XV20)

Clutch specifications
Clutch Fluid grade, distance from pedal to body floor and free pedal travel Cm. subsection 2.1. Length of semi-axles (standard): Cars with 4-cylinder engine: – Solara: • left 609 mm • right 843 mm – Camry: • left...

Clutch — description and testing
The clutch is dry, single-disc, diaphragm type, with hydraulic drive. The hydraulic drive circuit includes the master and slave cylinders in series, through which the force from the pedal is transmitted to the fork and...

Clutch — removal, inspection and installation
Clutch parts 1. Flywheel; 2. Friction disc; 3. Clutch housing; 4. Bolt; 5. Release bearing; 6. Fork; 7. Spherical fork support; 8. Cover Places to check friction disc wear 1. Overlays; 2. Damper springs; 3. Hub; 4....

Release bearing and fork — removal, inspection and installation
Removal 1. Disconnect the battery from ground. 2. Remove the transmission. 3. Remove the spring, take out the clutch release fork, and take the release bearing out of the fork. Examination Hold the outer race and check...

Clutch Master Cylinder — Removal and Installation
Removal 1. Disconnect the battery from ground. 2. Remove the cotter pin and disconnect the master cylinder push rod from the clutch pedal (the arrow indicates the clutch cylinder pusher fork pin). Disconnect the...

Clutch slave cylinder and accumulator — removal and installation
Slave cylinder Removal 1. Disconnect the battery from ground. 2. Raise the front of the car. 3. Disconnect the hydraulic tube from the cylinder, unscrew the two bolts (indicated by arrows) and remove the cylinder....

Bleeding the Clutch Hydraulic Drive
Bleeding the system will be required every time after disassembling and assembling the clutch hydraulic drive. 1. Fill the reservoir with fresh DOT-3 brake fluid (use of waste liquid is prohibited). 2. Raise the front...

Clutch Lock Switch — Checking and Adjusting
Clutch lock switch The switch is mounted behind the pedal. Checking and adjusting 1. Make sure that the engine starts only when the clutch pedal is fully depressed (check the pedal adjustment first, see. subsection...

Clutch slippage — causes and repair
What could cause the clutch to slip or not fully disengage when the pedal is pressed? Clutch slippage is manifested in the fact that, with a perfectly serviceable engine, the car does not climb well and accelerates...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Clutch Toyota 4Runner N120 (1989-1995)
➥ Clutch Toyota Corona T190 (1992-1997)
➥ Clutch Toyota RAV 4 XA10 (1994-2000)
➥ Clutch Toyota Cruiser 70 (1985-1996, diesel)
➥ Clutch and drive shafts Toyota Corolla Verso 3 (2004-2009)
➥ Clutch Toyota Carina T190 (1992-1996)

Link in different formats to this article

TEXTHTMLBB Code