Suspension — preliminary checks 1. Check tire wear. 2. Check tire pressure. Depending on the configuration, operating conditions and the quality of the tires installed, the tire pressure in the cold state is: In the front - 2.0-2.2 kPa In the rear -...
Front wheel alignment Checking and adjusting the convergence Check the amount of convergence. If it does not meet the specified conditions, then adjust. Convergence when checking: B - A = 1±2 mm To adjust: A) Remove the cover clamps. b)...
Hub and steering knuckle front suspension Removing Note: Installation is in reverse order of removal. After installation, check the alignment of the front wheels and the operation of the speed sensors (ABS). 1. Jack up the car, remove the front wheel....
Front suspension strut Removing Note: Installation is in reverse order of removal. After installation, check the alignment of the front wheels and the operation of the speed sensors (ABS). 1. Jack up the car, remove the front wheel....
Lower arm front suspension Removal and installation Note: Installation is in reverse order of removal. After installation, check the alignment of the front wheels. 1. Disconnect the anti-roll bar from the lower arm (see relevant section). Note:...
The lower ball joint of the front suspension — removal and installation Note: Installation is in reverse order of removal. 1. Remove the cotter pin and unscrew the nut. Tightening torque - 127.5 Nm 2. Mount the mount as shown in the figure and press out the stabilizer. 3. Using a puller,...
Stabilizer bar of the front suspension Removal and installation Note: Installation is in reverse order of removal. After installation, check the alignment of the front wheels. 1. Jack up the car, remove the front wheels. Tightening torque - 105 Nm 2. Turn...