Automatic car gearbox Toyota Camry 2 (XV20)

General information about automatic transmission
The automatic transmission includes a torque converter, 2 planetary gearboxes, hydraulically connected to multi-plate clutches and a band brake. The main gear and differential are mounted in the same housing with the...

Automatic transmission specifications
Clearance between the outer sheath of the throttle cable and the stop 1,016 mm Gear Shift Lever Lock System Resistance of the electromagnetic valve of the locking system (TMMK) 29 – 35 Ohm Resistance of the...

Automatic transmission maintenance
Maintenance of an automatic transmission consists of periodic inspection and checking for leaks from gaskets and seals, checking the level and condition of the fluid, replacing the fluid at the specified time and...

General diagnostics of automatic transmission
Preliminary check 1. Warm up the engine and transmission to normal operating temperature. 2. Check the transmission fluid level. 3. If the level is too low, add fluid and check again. 4. If the level is too high, drain...

Gear Shift Lever Cable — Adjustment and Replacement
Adjustment 1. Raise and support the front of the vehicle. 2. Remove the protective shields covering the space between the front of the vehicle and the lower cross member. 3. Loosen the shift lever nut on the gearbox...

Throttle Cable — Checking and Adjusting
1. Check how the throttle linkage functions. 2. If the valve does not open fully when the pedal is fully depressed, have an assistant hold the pedal depressed, loosen the adjusting nuts and adjust the cable so that the...

Ignition Interlock Switch — Checking and Replacing
The immobilizer switch prevents the engine from starting if any gear other than park or neutral is engaged. Checking the switch (4-cylinder models) Gear shift lever position Contact numbers, circuit between contacts is...

Gear Shift Lever Lock System
Gear Shift Lever Lock System (tMS system) 1. Lock system release button cover 2. Lock system release button 3. Lock system electronic control unit 4. Ignition lock solenoid valve 5. Brake light switch Gear Shift Lever...

Replacing automatic transmission seals
Drive axle shafts 1. Remove the axle shafts. 2. Remove the old seals using a pry bar or special tool. 3. Install new seals. Speedometer slave mechanism sealing ring The vehicle speed sensor and the speedometer slave...

Removal and installation of automatic transmission
Removal 1. Remove the hood. 2. Release the pressure in the fuel system. 3. Disconnect the negative battery cable. 4. Remove the battery and battery tray. 5. If the vehicle is equipped with a cruise control system,...

Electronic control system of automatic transmission
Elements of the electronic control system (4-cylinder engines) 1. Electronic control unit; 2. Throttle position sensor; 3. Switch; 4. Switch indicator light; 5. Brake light switch; 6. Solenoid valve N₂ of the shift...

Automatic transmission — operation and maintenance
All you need to do is learn the position of the transmission selector lever and its main positions: P - parking (parking brake); R - reverse (reverse); N - neutral; D - forward movement. So, start the engine, put the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Automatic gearbox Toyota Duet (1998-2004)
➥ Automatic gearbox Toyota Corona T190 (1992-1997)
➥ Automatic gearbox Toyota Cruiser 70 (1985-1996, diesel)
➥ Automatic gearbox Toyota Carina T190 (1992-1996)
➥ Automatic gearbox Toyota Corolla E80 (1983-1990)
➥ Automatic gearbox Toyota Highlander 1 (2000-2007, petrol)

Link in different formats to this article

TEXTHTMLBB Code