Diesel engines 3C-T car Toyota Vista 4 (V40)

Diesel engine ZS-T (2.2) — description
The ZS-T engine is in-line, 4-cylinder, 8-valve with an overhead camshaft. The engine displacement is 2.2 liters. The cylinders are numbered from the crankshaft pulley. Engine firing order: 1-3-4-2. The crankshaft is...

Removal the timing belt
1. (Models with power steering) Remove the power steering pump and power steering pump drive belt. a) While holding the power steering pump drive belt with your hand, loosen the pulley mounting nut as shown in the...

Installing the timing belt
Note: If the pulleys were not removed, proceed to step 6. 1. Install the crankshaft timing pulley. a) Align the keyway on the pulley with the key on the front nose of the crankshaft. b) Using a special mandrel (or a...

Cylinder head — removal
1. Drain the coolant. 2. Remove the air filter cover with air duct. 3. Disconnect the accelerator cable. 4. Remove the four clamps and disconnect the wiring harness. 5. Disconnect the crankcase ventilation hose. 6....

Cylinder head — installation
Note: Before installing parts, lubricate all rotating and sliding surfaces with oil. Replace all gaskets and seals with new ones. 1. Clean the mating surfaces of the cylinder head and cylinder block. 2. Install the...

Replacing camshaft seals
Note: There are two ways to replace the oil seal, depending on whether the camshaft oil seal housing has been removed or not. 1. If the camshaft oil seal housing is removed from the cylinder head. a) Using a screwdriver...

Vacuum line diagram
Vacuum line diagram. 1 - fuel injection pump, 2 - vacuum pump, 3 - absolute air pressure sensor in the intake manifold, 4 - electro-pneumatic valve of the absolute air pressure sensor in the intake manifold, 5 -...

Checking the recirculation system
Note: When installing or removing the manifold absolute pressure sensor or when removing the vacuum pipe, stop the engine first. 1. Install the vacuum gauges as shown in the figure. 2. Checking the mechanism. Note:...

Checking the EGR system components
1. Checking the EGR valve. Apply vacuum to the upper chamber of the valve and check for recirculation between A and B. Meaning: less than 100 mm Hg - no more than 200 mm Hg - yes 2. Checking the vacuum control solenoid...

Disassembly and assembly of the block and cylinder head
Note: disassemble and assemble the block and cylinder head using the assembly drawings as a guide. Parts removed during disassembly of the cylinder head. 1 - cylinder head cover, 2 - adjusting washer, 3 - valve tappet,...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Diesel engines Toyota Cruiser 100 (1998-2007)
➥ Fuel system (diesel) Toyota Corona T190 (1992-1997)
➥ Diesel engines 2C Toyota Carina T190 (1992-1996)
➥ Diesel engine Toyota Corolla E80 (1983-1990)
➥ Diesel engines Toyota RAV 4 XA20 (2000-2005)

Link in different formats to this article

TEXTHTMLBB Code