Electrical equipment of the car engine Toyota Camry 2 (XV20)

Location of charging and ignition system units
Location of the charging and ignition system units of 4-cylinder engines 1. Generator; 2. High voltage wires; 3. Ignition coil and unit module; 4. Starter; 5. Battery Location of the charging and ignition system units...

Technical characteristics of the engine electrical equipment
Ignition advance angle with grounded terminals TE1 and E1 8 – 12 degrees before TDC Ignition coil For 4-cylinder engines: Secondary winding resistance 9.7 – 16.7 kOhm For 6-cylinder engines: – resistance of the primary...

Battery — Checking and Replacing
Starting the engine in emergency situations See subsection 1.2.6. Examination 1. Disconnect both cables from the battery, starting with the negative terminal. 2. Check the color indicator. If the indicator is black,...

Power Cables — Checking and Replacing
Check the cables periodically along their entire length, damage, cracking or burning of cable insulation, as well as corrosion are not allowed. An unreliable battery connection can cause failures when starting the...

Ignition system — description and testing
Typical ignition system of the vehicles under consideration 1. Camshaft rotation sensor; 2. Crankshaft rotation sensor; 3. Other sensors; 4. From the battery; 5. Ignition coil; 6. Candle The vehicles in question are...

Ignition coils — replacement
On V6 engines, turn the ignition switch to the Off position, disconnect the connectors from the coils and check the resistance of the coil primary circuits. Please note: This procedure is not provided for 4-cylinder...

Checking the ignition timing
Attention! The ignition timing setting procedure applies to almost all vehicles covered in this Manual. If the ignition timing setting procedure specified in the vehicle's underhood plate differs from that described...

Electronic ignition unit — check
1. Disconnect from the electronic unit located under the brake master cylinder (v6 engine), connector and perform the following checks, referring to the diagram (see subsection 12.2.2. ) 2. Check for battery voltage at...

Battery Charging System — Description and Testing
The charging system consists of an alternator, a voltage regulator built into the generator, a charge control circuit, a battery, a fuse link and connecting wires. When these devices operate together, power is supplied...

Generator — removal and installation
Mounting a Generator on 4-Cylinder Engines 1. Adjusting bolt; 2. Wire; 3. Connector; 4. Generator; 5. Belt; 6. Axle bolt Mounting a Generator on a V6 Engine 1. Washer; 2. Wire; 3. Connector; 4. Adjusting bolt; 5....

Voltage Regulator and Brushes — Replacement
1. Remove the generator. 2. Unscrew the rear cover nuts and the generator terminal nut. 3. Remove the generator terminal insulating bushing. 4. Remove the rear cover of the generator. 5. Loosen the screws and remove the...

Engine starting system — design description
Starter and traction relay parts 1. Limiter; 2. Spring; 3. Spring washer; 4. Body; 5. Coupling; 6, 20. Spring; 7. Axis; 8. Traction relay; 9. Back cover; 10, 11. Seals; 12. Brush holder; 13, 14. Ring; 15. Yoke...

Starter motor — removal and installation
Starter terminals 1. Traction relay; 2. Starter; 3. Vice; 4. Switch If you suspect a faulty starter circuit, make sure the battery is charged, check the wiring for cleanliness and tightness, and check the Park/Neutral...

Starter Solenoid Relay — Removal and Installation
Removal 1. Remove the starter. 2. Mark the position of the traction relay on the starter by placing a mark on it. 3. Disconnect the starter bus. To disconnect the bus, unscrew the nut. 4. Loosen the starter gearbox...

Main faults of electrical equipment
Cause Method of elimination The starter does not rotate after the ignition is turned on The battery is discharged Charge the battery. Break in wire 50 to ignition switch lock, ignition switch wire damaged Repair the...

What should an owner of a car with an injection engine know?
Injector engines are superior to carburetor engines in many respects, for example, their efficiency and trouble-free starting in cold weather. Nevertheless, carburetor engines sometimes turn out to be more advantageous...

Turbocharger — General information on replacement
Rule N1 : don't even think about repairing a turbocharger at home. Rule N₂: you can replace a faulty turbocharger with a new one without much difficulty. Not so long ago there were times when a car with a turbocharger...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Engine electrical equipment Toyota Carina T190 (1992-1996)
➥ Engine electrical equipment Toyota Cruiser 100 (1998-2007)
➥ Engine electrical equipment Toyota Highlander 1 (2000-2007, petrol)
➥ Engine electrical equipment Toyota RAV 4 XA20 (2000-2005)
➥ Engine electrical equipment Toyota Corona T190 (1992-1997)

Link in different formats to this article

TEXTHTMLBB Code